Ceramic Coating Not Beading? Use This Foam Cannon Hack to Fix It Fast
Your ceramic coating should bead water like crazy. But over time, coatings can get clogged with grime, minerals, and road film—causing water to sheet instead of bead.
Before you assume your coating is gone, try this foam cannon hack using a special soap blend to unclog the surface and restore hydrophobic performance fast.
Why Ceramic Coatings Stop Beading
- ✅ Road film and grime clog the surface
- ✅ Hard water and minerals block the beading effect
- ✅ Cheap soaps or neglected washes build up residue
The coating is usually still intact—it just needs a deep clean.
The Foam Cannon Hack That Brings It Back
Here’s what you do:
- Add 2 oz of The Super Soaper
- Then add 2 oz of Pure Magic Cleaner Concentrate
- Fill the rest of your foam cannon bottle with warm water
- Foam the entire vehicle and let it dwell for 5–7 minutes
- Rinse thoroughly with high pressure and inspect water behavior
This combo breaks down contamination that blocks the beading effect—without harming your coating.
Want to See It in Action?
Watch the full YouTube breakdown and live test here:
What If It Still Doesn’t Bead?
If this method doesn’t fully revive the beading, try:
- ✅ Claying the surface with a mitt or clay towel
- ✅ Wiping down with a panel prep spray
- ✅ Reapplying a topper like Tough As Shell
Customer Testimonial
"I used 2 oz of Super Soaper and 2 oz of Pure Magic in my foam cannon like Jimbo showed—and the coating started beading again instantly. Unreal results."
— Marco V., Verified Customer
Products Used in the Video
Related Posts
Conclusion
If your coating isn’t beading—don’t panic.
This foam cannon hack with Super Soaper and Pure Magic Cleaner could be all you need to unclog the surface and get that slick, water-repelling finish back.
Grab the foam cannon combo now from Jimbo’s Detailing or shop it fast on Amazon.
